With type: CD-1, c13-1 (M132) C13-3 (M134) . One, carry out seriously " v equipment is current operating rules " concerned regulation. 2, carry out undermentioned concerned complement to set seriously: (one) make seriously before the job: 1, examination baseplate, anvil, lever of anvil, peen, slideway board, hammer should in good condition flawless. Wedge iron should tighten firm firm. Peen and anvil alignment do not have big amlposition. Pillar slideway board should accord with a regulation with mad peen clearance. 2, the marked that press place, examination hammer lever must not exceed those who express 2-2 regulation to allow a value in the deflection in peen cone: Watch 2-2 peen falls next weight (ton) 13 lever deflection allows a value (millimeter) 653, should grant hammer lever, peen and anvil to heat up 100 ° С to control. the condensate dropt outside cylinder, heat cylinder, a powerful person matching steam and section steam valve with a few vapour. 4, before forge is hit, must foretaste hammer, hammer of fan the air forbids when trying hammer, must place board or heating forging, in case hammer anvil burst. (2) make seriously in the job: 1, operate the fast, slow, light, heavy, actuate of forging hammer and stop, must accurate without by accident basis directorial demonstrative signal undertakes. Special attention wants to control the journey length of good joy stick when retype. 2, manipulator clip holds forging to answer clamp. Forging must be put in the central position forge of anvil to hit, forbid to slant dozen. Cut the triangular chisel when makings Ying Fangping, put. 3, forbid to be attacked for nothing, forbid what Leng Jin belongs to to press, delay, cut reach hammer broken job, forbid to weigh the forging with thin hammer, forbid to shut type die forging, forbid forge to hit temperature the forging under 900 ° С . 4, in working process, if cease time is longer (if lunch rests) should beat a head to write down go up in anvil, had involved a powerful person that take steam and section steam a powerful person. 5, if discover baseplate, anvil, anvil, peen, slideway and hammer lever have flaw, answer to quit the job instantly. (3) load board is put to make on anvil after the job peen slowly fall. CNC MillingCNC Machining