1. The installation of the milling cutter that take a power pursues the installation of milling cutter of 1 belt handle (1) collet of commonly used bedspring comes to the milling cutter of installation straight handle of straight handle milling cutter installation, if pursue,1a place is shown. When installation, tighten up nut, make bedspring covers radial contractive and the column handle clamp milling cutter. (2) when the installation of awl handle milling cutter carries photograph of ministry taper hole to be the same as with main shaft when dimension of handle of milling cutter awl, can load taper hole directly, use pull rod taut. Should use otherwise transfer awl is covered undertake installing, refer to graph 1b. 2. The installation of the milling cutter that take aperture is shown 2 times like the graph, the milling cutter that take a power should use milling cutter lever to install, insert one aspect of the matter of cone of milling cutter lever main shaft taper hole first, with pull rod taut. Adjust the appropriate position of milling cutter through sleeve, arbor other one aspect of the matter uses hanger bearing. Graph the sleeve of 3- of key of 2- of installation 1- main shaft of milling cutter of 2 belts aperture 4, nut of cutter shaft 5- pursues the 3 measure that are installation cylinder milling cutter pursue the measure A of milling cutter of 3 installation cylinder) installation arbor and milling cutter; B) cover on a few sleeve, twist on nut; C) mount hanger; D) screw nut CNC MillingCNC Machining